Burnside was farmland for its first hundred years of European settlement, part of William Boag's 1,700 acre farm. After 1945 much of Bryndwr and Burnside became new subdivisions, many built under the Group Housing Scheme, and the area was one of the most rapidly growing in New Zealand through the 1950s and 1960s. If your cylinder has failed, we can usually have hot water back on in Burnside within a day. If it is still working but showing its age, we can plan the swap at a time that suits you.
Burnside group housing: time for cylinder and pipe upgrades
Much of Burnside was built after 1945, many homes under the Group Housing Scheme, and through the 1950s and 1960s it was among the fastest-growing areas in New Zealand. Many homes of that era share similar plans, so the cylinder is often in a small cupboard off the hallway, and the original pipework may be a mix of materials patched over time.
Those cupboards are often tight for a modern cylinder. We measure and look at a taller, narrower model or a different location in the house. Moving from low pressure to mains pressure here usually means checking or replacing old pipe sections, and we quote that with the cylinder so nothing comes as a surprise. Taps and shower mixers made for low pressure may also need replacing to work properly afterwards.
Burnside lies south-east of the airport, where frost is frequent, so exposed pipes are wrapped and the relief outlet is placed where ice cannot seal it. Group houses from the 1950s often have timber floors with the pipes running underneath, which is where a hard frost does its damage, so we lag the runs nearest the vents. Seismic restraint to G12/AS1 goes on each replacement, and we look over the straps on any older unit we service. Comparing electric storage against a heat pump unit or an LPG system is worth doing before you decide, and we lay out the trade-offs plainly.
Local tip: In a Burnside group house, check whether your shower mixer is designed for low pressure before a mains upgrade, because it may need changing too.
Hot Water Cylinders in Burnside: Local Factors
Canterbury frosts can freeze and split exposed relief drains and pipework near the cylinder. We lag what is exposed and check the valves after a hard winter.
For anything else, see our plumbers in Burnside.
How We Handle Hot Water Cylinders in Burnside
We carry common cylinder sizes and valves, so most replacements in Burnside are done in a day once you have approved the quote.
Pricing: quotes are free, and every job gets a fixed price before we start, so there are no surprises on the invoice.
Hot Water Cylinders Jobs We Do in Burnside
- Cylinder valve replacement
- Leaking cylinder
- Electric cylinder replacement
- LPG water heater replacement
- Safe tray install
Hot Water Cylinders Burnside FAQs
Do Burnside group houses need new pipes for mains pressure?
Not always. We check the pipe material and condition, then tell you which sections, if any, need replacing.
How long does a cylinder replacement take?
Most straightforward replacements take a few hours. Upgrading from low pressure to mains pressure can take longer.
Can you replace an LPG water heater?
Yes. We install and replace LPG continuous flow and storage water heaters, including the gas connection and certification.
Hot Water Cylinders Near Burnside
- Hot Water Cylinders Avonhead
- Hot Water Cylinders Fendalton
- Hot Water Cylinders Ilam
- Hot Water Cylinders Bishopdale
- Hot Water Cylinders across Christchurch