Burnside was farmland for its first hundred years of European settlement, part of William Boag's 1,700 acre farm. After 1945 much of Bryndwr and Burnside became new subdivisions, many built under the Group Housing Scheme, and the area was one of the most rapidly growing in New Zealand through the 1950s and 1960s. From a single cooktop swap to a whole house run for hot water, heating and an outdoor bayonet, we size the LPG supply in Burnside so every appliance gets the pressure it needs, even with everything on at once.
Burnside group housing: simple routes for new gas
Burnside grew fast after 1945, when William Boag's old farm was subdivided and many homes were built under the Group Housing Scheme through the 1950s and 1960s. These houses share a lot of traits: modest single storey footprints, timber floors on piles, a ceiling cavity with room to move, and standard suburban sections with side access. For a gasfitter, they are among the easier homes in the city to work on.
A typical Burnside job is adding a gas hob when the kitchen is updated, or putting in a continuous flow water heater to replace an original cylinder. Because the floor is accessible, the pipe can run straight underneath from a bottle station on the side of the house to the kitchen and the water heater location. Where replacement homes have gone up on slabs, the route changes to the walls and roof.
Burnside is south-east of the airport, where frosts are frequent, and the small creeks here form the headwaters of the Waimairi Stream. We take the cold into account when choosing bottle capacity, and we keep bottle stations on firm, dry ground away from any damp low spots. Some older homes have had gas or coal gas pipe left behind from early heaters, which we trace and isolate. When we finish, we pressure test, commission each appliance and issue the certificate. Homes near Jellie Park and Burnside High School often have families running several showers at once, which we allow for in the sizing.
Local tip: Most Burnside homes have a subfloor hatch in a cupboard or hallway, so clear access to it before a gas install.
Gas Fitter in Burnside: Local Factors
In a Canterbury winter LPG bottles run down faster as heating and hot water demand climbs. An automatic changeover regulator means you swap to the full bottle without noticing.
For anything else, see our plumbers in Burnside.
How We Handle Gas Fitter in Burnside
Our gasfitters carry pipe, fittings, regulators and leak testing gear, so most appliance connections in Burnside are done in one visit.
Pricing: quotes are free, and every job gets a fixed price before we start, so there are no surprises on the invoice.
Gas Fitter Jobs We Do in Burnside
- Gas appliance replacement
- Gas certificate
- Outdoor gas bayonet
- New gas pipe run
- Gas leak test
Gas Fitter Burnside FAQs
How long does it take to add a gas hob to a Burnside group house?
Often a single visit, because the subfloor gives an easy route. We confirm after a site check.
What gas certificate will I get?
You get a gas certificate for the work, which is required for certain gas installations.
How much does gas fitting cost in Burnside?
Larger jobs, like a new supply line or several appliances, are priced after we assess the work.
Gas Fitter Near Burnside
- Gas Fitter Avonhead
- Gas Fitter Fendalton
- Gas Fitter Ilam
- Gas Fitter Bishopdale
- Gas Fitting across Christchurch